Measure all four sides of a property.
Upload one photo per included side. Each photo is calibrated independently, then its roofline and ridge runs are saved separately before the property totals are combined.
Build the staff measurement
- 1Property
- 2Calibrate
- 3Rooflines
- 4Ridges
- 5Review
Set up the property photos
Add the sides included in the requested lighting design. For a complete perimeter estimate, upload front, left, right, and back photos.
Optional additional pictures
Add a separately calibrated view for an L-shaped wing, detached garage, or another structure that is not fully visible in the four main photos.
Both optional picture slots are in use.
Photos stay in this browser during the staff session. They are not uploaded to TruShine, GHL, or an outside service.
Calibrate each photo
Select a side, choose “Mark reference,” then tap both ends of the known-width object selected on the first page.
This side is not calibrated yet.
Trace roofline and gutter runs
Complete each uploaded side. Every finished run remains separate in the staff audit.
Add ridge and peak runs
Trace ridge or peak lines on any side where they are requested. Skip if the project has roofline-only lighting.
Review the complete property
The 15% installation and material allowance is applied once to every measured run. All sides are combined below.